all pocket operators can be synchronized to an audio click track, as well as transmit this click track to other pocket operators and other gear. you need to configure a sync mode for each pocket operator. here's how to do it:
- press and hold the [function] button (func, record, * ) on the right, just below knob [B], and press [bpm] to toggle sync modes.
- keep holding the [function] button and press [bpm] repeatedly to toggle between different modes.
- there are five sync modes, where default is mode SY0 (sync off).
sync modes 2-5 are only available when a cable is connected to line in.
when sync is used the output signal will be split between audio (right) and sync (left).
mode | input | output |
SY0 | stereo | stereo |
SY1 | stereo | mono/sync |
SY2 | sync | stereo |
SY3 | sync | mono/sync |
SY4 | mono/sync | stereo |
SY5 | mono/sync | mono/sync |
please note: for external triggering make sure you use the right sync polarity, and that you use a signal that is maximum 5 Vpp (volt peak-to peak). any stronger signals need to be reduced before they can be used. failing to do so may harm the input and will not be covered by warranty.